How To Install Plasma Tv Wall Mount

Download Article

Download Article

Virtually people just put their plasma Television on a stand on a table or other piece of furniture. But what fun is that? I of the cool things virtually having a TV that's only 4 inches (10.2 cm) deep is the power to mount information technology right on the wall!

Steps

1. 1

   Purchase a wall mount from a reputable plasma TV dealer, and ensure that it fits your TV. Ensure you are purchasing the right wall mount for your Television set AND for the type of wall you will exist mounting your Tv on.

2. 2

   Consider what you will exist doing with your cables. If you are mounting your Television receiver on a stud wall it is possible to thread your cable down the space backside the wallboard. Running the cables this way looks great but involves a lot of effort. An alternative would be to use a surface mountain conduit. There are several like shooting fish in a barrel to fit conduits available on the market place that can produce some outstanding results.

   Advertizing

3. 3

   For mounting your TV on a stud wall follow the next few steps. Other wall type require that you follow the mount manufactures guidelines.

   1. Locate the wall studs in the wall y'all wish to hang the TV on. It is critical that the screws holding the TV to the wall are screwed into the solid wood of a stud, not just into the wallboard. The best mode to find a stud is with a stud finder, which is bachelor at any hardware store for less than $twenty. Be sure to notice the center of the stud for the best results.
   2. When you find the middle of a stud, marker it with pencil on the wall. Measure out the vertical distance betwixt the screw holes on the mount. After deciding how high to mount the Television, marking with pencil where you will place each screw.
   3. Double check that the mountain volition exist level using a level. Information technology is crucial that you mountain information technology level. Information technology will be hard to gear up later the fact if yous do it poorly, so please mensurate twice.
   4. Utilize big screws. Try #xiv x 1.5 inch screws. For #14 screws, drill a pilot hole 13/64" in diameter start.

4. 4

   Attach the mount with the screws. Double bank check to ensure that it is level.

5. 5

   If y'all are running your cables through the wall, now would be a good time to drill a pigsty into the wall to run your cables.

6. half dozen

   Hang the Tv on the mountain. Normally, this involves attaching rubber/plastic mounts to the dorsum of the TV, placing them through holes in the mount, and letting it settle into place.

7. 7

   Double check the stability of the TV, and ensure that it is firmly in place.

8. 8

   Connect your wiring and bask your Television set.

   Ad

Add New Question

• Question

  How do I mount a Goggle box without screwing holes?

  

  Screwing into a stud is really the just manner to ensure your Tv doesn't fall off the wall and shatter.

• Question

  How high should it exist mounted?

  

  Mount information technology as loftier as you want, but make sure the cords can reach the TV and that it's at to the lowest degree three inches from the ceiling.

• Question

  Could I mount a board to the back of my TV?

  

  It depends on which TV you have, but theoretically, yes, you lot could practise this.

• Question

  Do I need a Tv set aerial?

  

  Yes, it would be helpful.

• Question

  How do I tell what TV wall mount I have?

  

  Look at the box that came with the TV or mount for more information about it.

• Question

  How can get a mounted Television down?

  

  A mount is typically a frame hooked to the studs in the wall and information technology has a ledge with a lip. The piece continued to the boob tube slips over the lip and rests on the ledge. All yous need to exercise is lift the television and it will come gratuitous of the mountain. If information technology is hung high, be sure to stand on something very sturdy and accept someone holding onto yous.

• Question

  How do I access the outlet behind a wall mounted tv?

  

  Yous would need to move or adjust the wall mount to reach it, otherwise take the entire Television set off of the wall mountain.

Ask a Question

200 characters left

Include your email accost to get a message when this question is answered.

Submit

Advertizement

• When running cables through a wall get a face plate with brushes on the front end, future proofed for nix equally yous tin but fish a new cable through.

• Cutting a piece of cardboard to the dimensions of your new Goggle box and use it on the wall to get an idea of a good position.

• Consider running wires through the wall for all of your Telly inputs. It may toll more, just you never know when y'all'll buy that new Hi-Def Blu-Ray player or games console.

• Often, power outlets are placed side by side to a stud, then look for a stud there.

• Save money and time by using a surface mount conduit to hide or camouflage the cables between the AV equipment and the TV. This means you won't take to spend lots of fourth dimension and money fishing cables or re-plastering at a subsequently date when you demand to add together new cables.

• In new houses, studs are by and large placed 16 inches (40.six cm) apart. And so if yous find 1, you tin can await for one that far away. However, don't rely only on that measurement. Bank check for the stud with a stud finder.

• Buy a light amplification by stimulated emission of radiation level ($20-$thirty) to determine where your wall screws demand to get. You lot accept less of a chance of making a mistake than using a spirit level and pencil

• If you want to hide all of your audio video equipment out of sight or in some other room, you lot can install an infrared receiver to relay your remote controls' signals to your out of view equipment.

• Use a glaze hanger or wire to assistance fish the cables through your wall.

• "Futurity Proof" your installation past including a DVI/HDMI cable (or at least component cables) through the wall, even if you are non using them today. If you just run S-Video or Blended cables, there is a good take chances you'll want to upgrade after. For the toll of an actress $20 cable, just put it in the wall while you have it open.

• Don't mount it likewise high. Information technology'southward tempting to mount it at picture height, but well-nigh people observe it more relaxing to watch if the center of the Boob tube is around 40–45 inches (101.6–114.3 cm) off the flooring (about centre level while sitting). Yet, some people accept found that having the TV slightly higher can event in a more authentic cinematic experience and can brand console gameplay more immersive.

• If you're mounting to an uneven surface (like brick or rock), cutting a slice of MDF or plywood a little bigger than the mounting bracket. Deeply and properly mount it to the surface first, then mount the bracket to that.

• New power outlets and/or data cable outlets are best positioned above or below the TV bracket (simply still behind the TV). Power outlet boxes must accept a closed back; depression voltage video/data cables can use outlet boxes that accept an open back (this makes running additional video/data cables easier after the initial installation).

• If you lot're running cables in the wall, buy quality cables to prevent interference from power wires and other wiring in the walls. Once you get this mounted, you lot don't want to notice out that y'all have a trouble.

Cheers for submitting a tip for review!

Advertizing

• Make certain the mountain you buy can handle more the Television set'southward weight. If your Tv set weighs 50 lbs. wait for a mount that is capable of treatment 4x the TV weight or 200 lbs. It might sound like overkill, until a child pulls on the Idiot box and it falls on them or someone trips most the Telly and grabs it on their manner down. Beware of the inexpensive "knock off" mounts.

• After hanging the mount (before you lot place the TV on it), observe a fashion to add some weight to the mount to make sure it is admittedly firmly in place. Most flat screen TVs weight effectually 50-150 lbs.

• You should wire a proper wall outlet for your power source. Other wiring methods such equally running an extension string through the wall do not comply with building codes in nigh areas, and also pose a burn down danger.

• If you are mounting above a fireplace, make sure it is adequately vented and not trapping heat or the majority of the heat is not flowing directly to the TV.

• Before you buy any wall mount, check and mensurate your wall. E.g. measure the distance between studs. Most swivel mounts will non mount to studs spaced 24" apart. Nigh attach to sixteen" spaced studs, just some only mount to studs spaced 14" or less apart. This will help you select a mount that you volition exist able to adhere to the wall without expensive modifications to your wall.

• Any data cables going into the wall must exist to special code to pass whatever time to come inspection on your house (such every bit selling the firm), for burn down risk etc. When y'all are shopping for cables ensure you ask at the store. Y'all volition pay more but will not run the run a risk of having to pull them out after inspection.

• The biggest concern mounting on the wall is wiring in the wall. It's hard to be sure, but be careful non to drill or screw into whatever wiring. Certain models of stud finders also include a characteristic which volition detect live AC wiring.

Ad

About This Article

Thanks to all authors for creating a folio that has been read 933,003 times.

Is this article up to date?

Source: https://www.wikihow.com/Wall-Mount-a-Plasma-TV

Posted by: maynardbuourproy67.blogspot.com

Share this post